0-Needed Items - Arduino - No Solder with 3 components - Purchase

zoggins12/19/2022Comments are off for this post

of the following boards:
- Arduino Uno
- Arduino Nano
- Pre-programmed Arduino Uno from the RetroSpy store
USB cable(s) to connect the Arduino to your computer
A RetroSpy Xbox 9000 cable for each board, if two boards are required. Do one of the following:
- Buy a pre-made cable from the RetroSpy storestore
- Make you own using the instructions under Wiring – No Soldering Required
  - Xbox 9000 extension cable
  - DB9000 Male Breakout Board
  - DB9000 Male to 2 Female Splitter
  - Wires connect to the breakout board, like these
- Make you own using the instructions under Wiring – Soldering Required
  - Xbox 9000 extension cable
  - Wires to solder into the controller extension cable to go to the Arduino, like these
  - Wire cutters/strippers
  - Soldering iron and solder
  - Electrical tape and/or heat shrink tubing
  - Digital multimeter or a cheap continuity tester

Owner and primary developer of RetroSpy.

0-Needed Items – Arduino – No Solder with 3 components – Purchase